![background image](/i/zyxel/148487/zyxel-ies-6000/h/zyxel-ies-6000-035.png)
Chapter 2 Hardware Installation and Connections
IES-6000M User’s Guide
35
2.3.3 Installing a Splitter Chassis Card
The splitter card’s type and slot must match those of the line card to which it is to connect. For
example, install ASC1024 cards in the slots below an ALC line card in the main chassis (see
). Use the SEC1024 extension card with the VOP1248G VoIP line card.
Leave the slot covers on unused splitter slots.
Use the following procedure to install a splitter or extension card in the splitter chassis.
1
If there is one splitter chassis below the main IES-6000 main chassis, install a line card’s
splitter or extension cards below the line card and in adjacent slots (a management
switch card does not need a splitter chassis card).
If there are two splitter chassis below the main IES-6000 main chassis, install the splitter
or extension cards in the splitter chassis slots that correspond to the slot number of the
line card in the main chassis.
2
Grasp the center of the front panel of the card with one hand and place the other hand
under the card to support it.
3
Insert the card into the slot and push it in until the front panel of the card is flush with the
front panel of the splitter chassis.
4
Tighten the two thumbscrews.
Figure 14
Installing a Splitter Chassis Card