![background image](/i/zyxel/148487/zyxel-ies-6000/h/zyxel-ies-6000-048.png)
Chapter 2 Hardware Installation and Connections
IES-6000M User’s Guide
48
This installation scenario requires three MDFs. Please refer to the following figure for the
connection schema.
• MDF 1 is the original MDF used for telephone connections only.
• MDF 2 is used for telephone connections only.
• MDF 3 is for DSL service connections.
"
Change the wiring from MDF 1 to MDF 3 for telephone subscribers who want
DSL service.
Figure 27
Installation Scenario B
Use the following procedure for this MDF installation scenario.
1
Connect the Telco-50 connector end of the cable you want for DSL service to the Telco-
50 connector labeled
USER
on the splitter chassis rear panel.
2
Connect the wiring on the other side of the Telco-50 cable to the upper ports of MDF 3
using a punch-down tool.
3
Connect the telephone wiring from the end-user’s DSL modem(s) to the lower ports of
MDF 3.
4
Connect the Telco-50 connector end of the cable you want for phone service to the
Telco-50 connector labeled
CO
on the splitter chassis rear panel.