IES-6000M User’s Guide

59

C

H A P T E R

3  

Maintenance

This chapter describes how to perform maintenance on the system hardware.

3.1  Fan Maintenance

This section describes how to change a fan fuse or a fan module on the IES-6000.

3.1.1  Procedure to Remove and Install the Fan Module

The IES-6000M has a hot-swappable fan module. The fan module is located above the slots 
and below the power modules on the front panel. Replace the entire fan module if the fuse is 
not the problem. Return any malfunctioning fan modules to the manufacturer.

Perform the following procedure to remove the fan module in order to change a fan fuse or the 
fan module.

1

Loosen the thumbscrews on the front of the fan module.

2

Slide out the fan module.

3

Replace the fuse if it is burnt out (see 

Appendix A on page 71

 for fuse information). If 

the fuse is not the problem, use a different fan module from the manufacturer.

4

Slide the fan module back into the fan module slot.

5

Tighten the thumbscrews.

Figure 37   

Loosen the Thumbscrews on the IES-6000 Fan Module