Chapter 2 Hardware Installation and Connections
IES-6000M User’s Guide
38
Figure 18
IES-6000 Front Panel Telco-50 Connections (2 Splitter Chassis)
Follow these directions if there are three splitter chassis below the IES-6000M main chassis.
You will need three splitter chassis when using the ACL1272G-51 line card for example.
• Use a short Telco-50 cable to connect a line card’s
49-72
Telco-50 connector to the Telco-
50 connector on the corresponding (in the same slot) splitter card of the top splitter
chassis.
• Use a medium Telco-50 cable to connect a line card’s
25-48
Telco-50 connector to the
Telco-50 connector on the corresponding splitter card of the middle splitter chassis.
• Use a long Telco-50 cable to connect a line card’s
1-24
Telco-50 connector to the Telco-50
connector on the corresponding splitter card of the bottom splitter chassis.
