Chapter 2 Hardware Installation and Connections
IES-6000M User’s Guide
46
Figure 24
Installation Overview Example
You can also attach RJ-11 connectors to the Telco-50 cable and connect directly to a DSL
modem(s) or patch panel. The following sections describe typical installation scenarios.
2.4.8.1 MDF Installation Scenario A
You want to install the IES-6000 in an environment where there are no previously installed
MDFs. There is no phone service and you want to install the IES-6000 for data-access only.
No connection from the Telco-50 CO connector is necessary. G.SHDSL connections carry data
only, thus they are best suited to this installation scenario.
You may connect using an MDF or attach RJ-11 connectors to the non-IES-6000 end of the
Telco-50 cable and then connect to DSL modems directly.
