![background image](/i/zyxel/148487/zyxel-ies-6000/h/zyxel-ies-6000-069.png)
Chapter 4 Hardware Troubleshooting
IES-6000M User’s Guide
67
Figure 44
Testing In-house Wiring
Table 3
Testing In-house Wiring
STEP
TEST
A
Wiring problem between the CO and MDF 1.
Connect a standard telephone to MDF 1. If there is no dial tone, then a problem with the wire
or wire connections between MDF 1 and the CO exists. Contact your telephone company for
troubleshooting.
B
Wiring problem between MDF 1 and MDF 2.
Connect a telephone to the upper port of MDF 2. If there is no dial tone, then the problem is
between MDF 1 and MDF 2. Check the telephone wire and connections between MDFs 1
and 2.
C
Wiring problem between MDF 2 and the USER Telco-50 connector on the splitter
chassis.
Disconnect the Telco-50 cable from the splitter chassis’ Telco-50 CO connector. Connect a
telephone to the appropriate pins of the Telco-50 cable’s Telco-50 connector.
If there is no dial tone, then the problem is between the splitter chassis Telco-50 CO
connector and MDF 2.
Check the Telco-50 cable’s pin assignments (refer to the line card User’s Guide for the proper
pin assignments). Replace the Telco-50 cable if the pin assignments are okay and there is
still no dial tone.