Инструкция для ZYXEL NWA3550-N

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 10 Device HA

NWA3000-N Series User’s Guide

132

The following table describes the labels in this screen.

Table 45

Configuration > Device HA > Active-Passive Mode

LABEL

DESCRIPTION

Show / Hide
Advanced
Settings

Click this button to display a greater or lesser number of configuration
fields.

Device Role

Select the device HA role that the NWA3000-N series AP plays in the
virtual router. Choices are:

Master

- This NWA3000-N series AP is the master NWA3000-N series

AP in the virtual router. This NWA3000-N series AP uses the virtual IP
address for each monitored interface.

Note: Do not set this field to

Master

for two or more NWA3000-N

series APs in the same virtual router (same cluster ID).

Backup

- This NWA3000-N series AP is a backup NWA3000-N series AP

in the virtual router. This NWA3000-N series AP does not use any of the
virtual IP addresses.

Priority

This field is available for a backup NWA3000-N series AP. Type the
priority of the backup NWA3000-N series AP. The backup NWA3000-N
series AP with the highest value takes over the role of the master
NWA3000-N series AP if the master NWA3000-N series AP becomes
unavailable. The priority must be between 1 and 254. (The master
interface has priority 255.)

Enable
Preemption

This field is available for a backup NWA3000-N series AP. Select this if
this NWA3000-N series AP should become the master NWA3000-N
series AP if a lower-priority NWA3000-N series AP is the master when
this one is enabled. (If the role is master, the NWA3000-N series AP
preempts by default.)

Cluster Settings
Cluster ID

Type the cluster ID number. A virtual router consists of a master
NWA3000-N series AP and all of its backup NWA3000-N series APs. If
you have multiple NWA3000-N series AP virtual routers on your
network, use a different cluster ID for each virtual router.

Authentication

Select the authentication method the virtual router uses. Every
interface in a virtual router must use the same authentication method
and password. Choices are:

None

- this virtual router does not use any authentication method.

Text

- this virtual router uses a plain text password for authentication.

Type the password in the field next to the radio button. The password
can consist of alphanumeric characters, the underscore, and some
punctuation marks (+-/*= :; .! @$&%#~ ‘ \ () ), and it can be up to
eight characters long.

IP AH (MD5)

- this virtual router uses an encrypted MD5 password for

authentication. Type the password in the field next to the radio button.
The password can consist of alphanumeric characters, the underscore,
and some punctuation marks (+-/*= :; .! @$&%#~ ‘ \ () ), and it can
be up to eight characters long.