![background image](/i/zyxel/149189/zyxel-nwa3550-n/h/zyxel-nwa3550-n-212.png)
Chapter 15 System
NWA3000-N Series User’s Guide
212
15.6.4 Configuring SSH
Click
Configuration > System > SSH
to open the following screen. Use this
screen to configure your NWA3000-N series AP’s Secure Shell settings.
Note: It is recommended that you disable Telnet and FTP when you configure SSH for
secure connections.
Figure 96
Configuration > System > SSH
The following table describes the labels in this screen.
Table 74
Configuration > System > SSH
LABEL
DESCRIPTION
Enable
Select the check box to allow or disallow the computer with the IP
address that matches the IP address(es) in the
Service Control
table to
access the NWA3000-N series AP CLI using this service.
Version 1
Select the check box to have the NWA3000-N series AP use both SSH
version 1 and version 2 protocols. If you clear the check box, the
NWA3000-N series AP uses only SSH version 2 protocol.
Server Port
You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Server
Certificate
Select the certificate whose corresponding private key is to be used to
identify the NWA3000-N series AP for SSH connections. You must have
certificates already configured in the
My Certificates
screen.
Apply
Click
Apply
to save your changes back to the NWA3000-N series AP.
Reset
Click
Reset
to return the screen to its last-saved settings.