Инструкция для ZYXEL NWA3550-N

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 17 File Manager

NWA3000-N Series User’s Guide

242

These files have the same syntax, which is also identical to the way you run CLI
commands manually. An example is shown below

# enter configuration mode

configure terminal

# change administrator password

username admin password 4321 user-type admin

#configure default radio profile, change 2GHz channel to 11 & Tx output power

# to 50%

wlan-radio-profile default

2g-channel 11

output-power 50%

exit

write

While configuration files and shell scripts have the same syntax, the NWA3000-N
series AP applies configuration files differently than it runs shell scripts. This is
explained below.

You have to run the aforementioned example as a shell script because the first
command is run in

Privilege

mode. If you remove the first command, you have to

run the example as a configuration file because the rest of the commands are
executed in

Configuration

mode.

Comments in Configuration Files or Shell Scripts

In a configuration file or shell script, use “#” or “!” as the first character of a
command line to have the NWA3000-N series AP treat the line as a comment.

Your configuration files or shell scripts can use “exit” or a command line consisting
of a single “!” to have the NWA3000-N series AP exit sub command mode.

Note: “exit” or “!'” must follow sub commands if it is to make the NWA3000-N series

AP exit sub command mode.

Table 87

Configuration Files and Shell Scripts in the NWA3000-N series AP

Configuration Files (.conf)

Shell Scripts (.zysh)

• Resets to default configuration.
• Goes into CLI

Configuration

mode.

• Runs the commands in the configuration

file.

• Goes into CLI