![background image](/i/zyxel/149189/zyxel-nwa3550-n/h/zyxel-nwa3550-n-268.png)
Chapter 21 Troubleshooting
NWA3000-N Series User’s Guide
268
One of the LEDs does not behave as expected.
1
Make sure you understand the normal behavior of the LED. See
Section 1.7 on
page 27
.
2
Check the hardware connections. See the Quick Start Guide.
3
Inspect your cables for damage. Contact the vendor to replace any damaged
cables.
4
Disconnect and re-connect the power adaptor or PoE power injector to the
NWA3000-N series AP.
5
If the problem continues, contact the vendor.
21.3 NWA3000-N series AP Access and Login
I forgot the IP address for the NWA3000-N series AP.
1
The default IP address is
192.168.1.2
.
2
Use the commands through the console port to check the IP address. Connect
your computer to the
CONSOLE
port using a console cable. Your computer should
have a terminal emulation communications program (such as HyperTerminal) set
to VT100 terminal emulation, no parity, 8 data bits, 1 stop bit, no flow control and
115200 bps port speed.
3
If this does not work, you have to reset the device to its factory defaults. See
I cannot see or access the
Login
screen in the web configurator.
1
Make sure you are using the correct IP address.
• The default IP address is 192.168.1.2.
• If you changed the IP address, use the new IP address.