![background image](/i/epson/156188/epson-stylus-pro-9000/h/epson-stylus-pro-9000-013.png)
6
6
|
Introduction
Year 2000 Ready
Your EPSON printer is
Year 2000 Ready
. However, be sure the other parts
of your computer system are also ready for the year 2000.
Important Safety Instructions
Before using your printer and RIP Station 5100, read the following safety
instructions to make sure you use the equipment safely and effectively.
•
Turn off and unplug the printer (and RIP Station 5100) before
cleaning. Clean with a damp cloth only. Do not spill liquid on the
printer (or RIP Station 5100).
•
Do not place the printer (or RIP Station 5100) on an unstable surface or
near a radiator, heating vent, or in direct sunlight. Avoid areas subject to
rapid changes in temperature and humidity or shock and vibrations.
•
Place the printer (and RIP Station 5100) on a flat surface. They will not
operate properly if they are tilted or at an angle.
•
Do not block or cover the openings in the printer case (or RIP Station
5100 case) or insert objects through the slots.
•
Use only the type of power source indicated on the label.
•
Connect all equipment to properly grounded power outlets. Avoid using
outlets on the same circuit as photocopiers or air control systems that
regularly switch on and off.
•
Place the printer (and RIP Station 5100) near a wall outlet where the
plugs can be easily unplugged.
Placez l’imprimante près d’une prise de contacte où la fiche peut être
débranchée facilement.
•
Do not let the power cords become damaged or frayed.
•
If you use an extension cord with the printer, make sure the total ampere
rating of the devices plugged into the extension cord does not exceed the
cord’s ampere rating. Also, make sure the total ampere rating of all
devices plugged into the wall outlet does not exceed the wall outlet’s
ampere rating.
Caution
Always turn the printer
off using the
Power
button. When you press
this button, the
Operate
light flashes briefly then
goes out. Do not unplug
the printer or turn off the
power to the printer until
the
Power
light is off.
This ensures that the
print head is safely
capped.