B-2
B-2
|
Using EPSON Drivers and Utilities for Macintosh
3. Connect one end of the interface cable to the serial connector on the
back of the printer.
4. Connect the other end of the interface cable to either the modem port or
printer port on the Macintosh. (Some Macintosh PowerBook
®
models
have only one serial port.)
5. Turn on the printer by pressing the
Power
button.
6. Turn on your Macintosh.
See the next section for instructions on installing the printer software. You
must install the printer software before using your printer.
Setting Up Your Software
Before you install the drivers and utilities, you need to make sure your
Macintosh meets the minimum system requirements. Then follow the
procedures for installing the software and selecting the printer. This section
covers:
•
Checking system requirements
•
Installing the software
•
Selecting your printer in the chooser
Note
If your Macintosh has a
built-in modem, connect
the interface cable to the
printer port.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
