3-16
3-16
|
Maintaining and Transporting the Printer
Moving the Printer Without the Leg Assembly
When you need to move the printer a longer distance, and you can’t safely
roll it, you may need to remove the leg assembly. Follow these steps:
1. First turn off the printer and make sure the print head is in the home
(far right) position. If not, turn the printer back on, wait until the print
head moves to the home position, then turn off the printer.
2. Remove the following parts:
•
Ink cartridges
•
Power cord
•
Interface cable
•
Paper hammock
•
Roll paper spindles
•
All paper or other media
•
Optional auto take-up reel (if installed)
After you remove the ink cartridges, store them in separate, resealable
plastic bags.
3. Make sure the ink cartridge clamps are in the upright position (closed).
Leave the ink compartment cover open. Use tape to hold the cover and
the cartridge clamps in place. This automatically closes the ink valves.
Caution
If for any reason the
printer will not be level
during shipping, a service
technician must drain all
ink from the printer
before it is shipped.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
