A-2
A-2
|
Installing an Ethernet Interface Card
4. Slide the interface card along the slots on both sides of the
compartment. Push it in firmly to fully insert the connector into the
printer’s internal socket.
5. Secure the interface card in the slot with the two screws included with
the card.
6. Make sure the printer is turned off. Then plug in the power cord.
7. To initialize the card, turn on the printer while holding down the status
sheet button on the card for about 5 seconds.
8. Connect the appropriate Ethernet cable to the card with an RJ-45
connector.
To remove an interface card, follow the above steps in reverse order.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
