![background image](/i/infiniti/147943/infiniti-fx35-2007-fx45-2007/h/infiniti-fx35-2007-fx45-2007-113.png)
WARNING
O
Do not use the HomeLink Universal
Transceiver with any garage door
opener that lacks safety stop and re-
verse features as required by federal
safety standards. (These standards be-
came effective for opener models manu-
factured after April 1, 1982). A garage
door opener which cannot detect an ob-
ject in the path of a closing garage door
and then automatically stop and re-
verse, does not meet current federal
safety standards. Using a garage door
opener without these features increases
the risk of serious injury or death.
O
During the programming procedure,
your garage door or security gate will
open or close (if the transmitter is within
range). Make sure that people and ob-
jects are clear of the garage door, gate,
etc. that you are programming.
O
Your vehicle’s engine should be turned
off while programming the HomeLink
Universal Transceiver.
PROGRAMMING HomeLink
To program your HomeLink
Universal
Transceiver to operate a garage door,
gate, or entry door opener, home or office
lighting, you need to be at the same loca-
tion as the device. Note: Garage door
openers (manufactured after 1996) have
“rolling code protection”. To program a
garage door opener equipped with “roll-
ing code protection”; you will need to use
a ladder to get up to the garage door
opener motor to be able to access the
“smart or learn” program button.
1. To begin, press and hold the 2 outer
HomeLink
buttons (to clear the
memory) until the indicator light
q
A
blinks (after 20 seconds). Release
both buttons.
2. Position the end of the hand-held
transmitter 1-3 inches away from the
HomeLink surface.
SIC3040
Instruments and controls
2-47
w
06.6.26/S50-D/V5.0
X