![background image](/i/infiniti/147943/infiniti-fx35-2007-fx45-2007/h/infiniti-fx35-2007-fx45-2007-240.png)
When the vehicle speed lowers to less
than approximately 45 MPH (72 km/h),
the LDW system enters standby mode.
When the vehicle speed increases to more
than 45 MPH (72 km/h) again, the LDW
system activates.
Temporary disabled status at high
temperature
If the vehicle is parked in direct sunlight
under high temperature conditions (over
approximately 104°F (40°C)) and then
started, the lane departure warning
system may cancel automatically. The
LDW switch ON indicator will blink.
When the interior temperature is reduced,
the system will again operate automati-
cally and the LDW switch ON indicator il-
luminates.
Lane Departure Warning (LDW)
camera unit maintenance
The LDW camera unit
q
1
for the LDW sys-
tem is located inside the map light cover.
To keep the LDW system operating prop-
erly, be sure to observe the following:
O
Always keep the windshield clean. The
sensing capability of the camera unit
depends on the condition of the wind-
shield. See “Cleaning interior” in the
“7. Appearance and care” section for
cleaning instruction.
O
Do not strike or damage the areas
around the camera unit. Do not touch
the camera lens or remove the screw
located on the camera unit. Doing so
could cause failure or malfunction. If
the camera unit is damaged due to an
accident, contact an INFINITI dealer.
O
Do not attach a sticker (including
transparent material) or install an ac-
cessory near the camera unit. This
could cause failure or malfunction.
O
Do not place reflective materials, such
as a white paper or mirrors on the in-
strument panel. Reflection of the sun-
light may adversely affect the camera
unit’s lane marker detection capa-
bility.
SSD0412
5-22
Starting and driving
w
06.6.26/S50-D/V5.0
X