![background image](/i/infiniti/147943/infiniti-fx35-2007-fx45-2007/h/infiniti-fx35-2007-fx45-2007-229.png)
1. Move the selector lever into the P
(Park) position.
2. Turn the ignition key slightly in the ON
direction.
3. Turn the key toward the LOCK posi-
tion.
4. Remove the key.
If the key is removed from the ignition
switch, the selector lever cannot be
moved from P (Park) position.
The se-
lector lever can be moved if the ignition
switch is in the ON position and the foot
brake pedal is depressed.
There is an OFF position
q
1
in between
LOCK and ACC, although it does not show
on the lock cylinder. When the ignition is
in OFF the steering wheel is not locked.
In order for the steering wheel to be
locked, it must be turned about 1/6 of a
turn clockwise from the straight up posi-
tion.
To lock the steering wheel, turn the key to
the LOCK position. Remove the key. To un-
lock the steering wheel, insert the key and
turn it gently while rotating the steering
wheel slightly right and left.
KEY POSITIONS
The switch includes an anti-theft steering
lock device.
LOCK (Normal parking position) (0)
The ignition key can only be removed
when the switch is in this position.
OFF (1)
The engine can be turned off without
locking the steering wheel.
The ignition lock is designed so that the
key cannot be turned to LOCK and re-
moved until the selector lever is moved to
the P (Park) position.
ACC (Accessories) (2)
This position activates electrical accesso-
ries such as the radio when the engine is
not running.
ON (Normal operating position) (3)
This position turns on the ignition system
and the electrical accessories.
START (4)
This position activates the starter motor,
starting the engine.
INFINITI VEHICLE IMMOBILIZER
SYSTEM
The INFINITI Vehicle Immobilizer System
will not allow the engine to start without
the use of the registered key.
If the engine fails to start using a regis-
tered key (for example, when interference
is caused by another registered key, an
automated toll road device or automated
payment device on the key ring), restart
the engine using the following proce-
dures:
1. Leave the ignition switch in the ON po-
sition for approximately 5 seconds.
2. Turn the ignition switch to the OFF or
LOCK position and wait approximately
10 seconds.
3. Repeat step 1 and 2.
4. Restart the engine while holding the
device (which may have caused the in-
terference) separate from the regis-
tered key.
If this procedure allows the engine to
start, INFINITI recommends placing the
registered key on a separate key ring to
avoid interference from other devices.
Starting and driving
5-11
w
06.6.26/S50-D/V5.0
X