![background image](/i/infiniti/147943/infiniti-fx35-2007-fx45-2007/h/infiniti-fx35-2007-fx45-2007-287.png)
WARNING
Always follow the instructions below. Failure
to do so could result in damage to the charg-
ing system and cause personal injury.
1. If the booster battery is in another ve-
hicle
q
A
, position the two vehicles (
q
A
and the jumped vehicle:
q
B
) to bring
their batteries into close proximity to
each other.
Do not allow the two vehicles to touch.
2. Apply parking brake. Move the se-
lector lever to the P (Park) position.
Switch off all unnecessary electrical
systems (light, heater, air conditioner,
etc.).
3. Remove vent caps on the battery (if so
equipped). Cover the battery with an
old cloth
q
C
to reduce explosion
hazard.
4. Connect jumper cables in the sequence
as illustrated (
q
1
→
q
2
→
q
3
→
q
4
).
CAUTION
O
Always connect positive (+) to positive
(+) and negative (−) to body ground (for
example, strut mounting bolt, etc. — not
to the battery).
O
Make sure the jumper cables do not
touch moving parts in the engine com-
partment and that the cable clamps do
not contact any other metal.
5. Start the engine of the booster vehicle
q
A
and let it run for a few minutes.
6. Keep the engine speed of the booster
vehicle
q
A
at about 2,000 rpm, and
start the jumped vehicle
q
B
in the nor-
mal manner.
CAUTION
Do not keep the starter motor engaged for
more than 10 seconds. If the engine does not
start right away, turn the key off and wait 3
to 4 seconds before trying again.
SCE0450A
VQ35DE engine
In case of emergency
6-11
w
06.6.26/S50-D/V5.0
X