![background image](/i/infiniti/147943/infiniti-fx35-2007-fx45-2007/h/infiniti-fx35-2007-fx45-2007-115.png)
tinue to press and hold the HomeLink
button (note steps 2 through 4 under
“Programming HomeLink ”) while you
press and re-press (“cycle”) your hand-
held transmitter every 2 seconds until the
indicator light flashes rapidly (indicating
successful programming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damage to the garage door opener compo-
nents.
OPERATING THE HomeLink
UNIVERSAL TRANSCEIVER
The HomeLink
Universal Transceiver
(once programmed) may now be used to
activate the garage door, etc. To operate,
simply press the appropriate programmed
HomeLink Universal Transceiver button.
The red indicator light will illuminate
while the signal is being transmitted.
PROGRAMMING TROUBLE-
DIAGNOSIS
If the HomeLink does not quickly learn
the hand-held transmitter information:
O
replace the hand-held transmitter bat-
teries with new batteries.
O
position the hand-held transmitter
with its battery area facing away from
the HomeLink surface.
O
press and hold both the HomeLink
and hand-held transmitter buttons
without interruption.
O
position the hand-held transmitter 2
to 5 in (50 to 127 mm) away from the
HomeLink surface. Hold the transmit-
ter in that position for up to 15 sec-
onds. If HomeLink
is not pro-
grammed within that time, try holding
the transmitter in another position -
keeping the indicator light in view at
all times.
If you continue to have programming diffi-
culties, please contact the INFINITI Con-
sumer Affairs Department. The phone
numbers are located in the Foreword of
this Owner’s Manual.
CLEARING THE PROGRAMMED
INFORMATION
Individual buttons cannot be cleared,
however to clear all programming, press
and hold the two outside buttons and re-
lease when the indicator light begins to
flash (approximately 20 seconds).
REPROGRAMMING A SINGLE
HomeLink BUTTON
To reprogram a HomeLink
Universal
Transceiver button, complete the fol-
lowing.
1. Press and hold the desired HomeLink
button.
Do not
release the button until
step 4 has been completed.
2. When the indicator light begins to
flash slowly (after 20 seconds), posi-
tion the hand-held transmitter 2 to 5
in (50 to 127 mm) away from the
HomeLink surface.
3. Press and hold the hand-held trans-
mitter button.
4. The HomeLink
indicator light will
flash, first slowly and then rapidly.
When the indicator light begins to
flash rapidly, release both buttons.
The HomeLink
Universal Transceiver
button has now been reprogrammed. The
new device can be activated by pushing
the HomeLink button that was just pro-
grammed. This procedure will not affect
any other programmed HomeLink
but-
tons.
Instruments and controls
2-49
w
06.6.26/S50-D/V5.0
X