![background image](/i/infiniti/147943/infiniti-fx35-2007-fx45-2007/h/infiniti-fx35-2007-fx45-2007-148.png)
1. Apply the parking brake, and set the
selector lever to the P (Park) position.
2. Turn the ignition ON.
3. Adjust the driver’s seat, steering
column and outside mirrors to the de-
sired positions by manually operating
each adjusting switch. For additional
information, see “Seats” in the “1.
Safety — Seats, seat belts and supple-
mental restraint system” section and
“Steering wheel” and “Outside mir-
rors” earlier in this section.
During this step, do not turn the igni-
tion to any positions other than ON.
4. Push the SET switch and, within 5 sec-
onds, push the memory switch (1 or 2)
fully for at least 1 second.
The indicator light for the pushed memory
switch will come on and stay on for ap-
proximately 5 seconds after pushing the
switch. After the indicator light goes off,
the selected positions are stored in the
selected memory (1 or 2).
If a new memory is stored in the same
memory switch, the previous memory will
be deleted.
Linking a keyfob or Intelligent Key
to a stored memory position
A keyfob or Intelligent Key can be linked
to a stored memory position with the fol-
lowing procedure.
1. Follow the steps for storing a memory
position.
2. While the indicator light for the
memory switch being set is illumi-
nated for 5 seconds, press the
button on the keyfob or Intelli-
gent Key. The indicator light will blink.
After the indicator light goes off, the
keyfob or Intelligent Key is linked to
that memory setting.
With the key removed from the ignition
switch, press the
button on the
keyfob or Intelligent Key. The driver’s
seat, steering wheel and outside mirrors
will move to the memorized position.
Confirming memory storage
O
Turn the ignition ON and push the SET
switch. If the main memory has not
been stored, the indicator light will
come on for approximately 0.5 sec-
onds. When the memory has stored
the position, the indicator light will
stay on for approximately 5 seconds.
O
If the battery cable is disconnected, or
if the fuse opens, the memory will be
canceled. In such a case, reset the de-
sired positions using the following
procedures.
1. Open and close the driver’s door more
than two times with the ignition key in
the LOCK position.
2. Reset the desired position using the
previous procedure.
Selecting the memorized position
1. Set the selector lever to the P (Park)
position.
SPA2185
3-32
Pre-driving checks and adjustments
w
06.6.26/S50-D/V5.0
X