![background image](/i/infiniti/147943/infiniti-fx35-2007-fx45-2007/h/infiniti-fx35-2007-fx45-2007-239.png)
LANE DEPARTURE WARNING (LDW)
SYSTEM OPERATION
The LDW system has an automatic mode
and manual mode.
In the automatic mode, the LDW system
automatically turns on when the ignition
switch is turned to the ON position. The
LDW system ON indicator
q
2
located on
the LDW switch
q
1
illuminates, indicating
that the system is on.
To cancel the LDW system, push the LDW
switch
q
1
to turn off the LDW system ON
indicator
q
2
. To turn on the system, push
the LDW switch
q
1
again.
In the manual mode, the LDW system will
be off when the ignition switch is turned
to the ON position. The LDW switch must
be pushed to turn on the system.
To change modes, push and hold the LDW
switch
q
1
for more than 4 seconds when
the LDW system ON indicator
q
2
is off. A
chime will sound and blinking of the LDW
system indicator indicates that the mode
change has been completed.
When the vehicle approaches either the
left or the right of the traveling lane while
driving over approximately 45 MPH (72
km/h), the LDW indicator
q
3
on the in-
strument panel flashes and a chime
sounds to alert the driver.
When you use the lane change signal and
change your traveling lane, the LDW
system will enter the standby mode until
the lane change is completed. Once the
vehicle completes the lane change and
the camera detects lane markers, the LDW
system starts again to monitor lane mark-
ers.
SIC2554
SSD0411
Starting and driving
5-21
w
06.6.26/S50-D/V5.0
X