![background image](/i/infiniti/147943/infiniti-fx35-2007-fx45-2007/h/infiniti-fx35-2007-fx45-2007-082.png)
High beam indicator light
(Blue)
This light comes on when the headlight
high beam is on and goes out when the
low beam is selected.
Intelligent Cruise Control
system MAIN switch
indicator light (Green; if so
equipped)
The light comes on when the ICC system
MAIN switch is pushed. The light goes out
when the MAIN switch is pushed again.
While the MAIN switch indicator light
comes on, the ICC system is operational.
Intelligent Cruise Control
system set switch indicator
light (if so equipped)
The light comes on while the vehicle
speed is controlled by the Intelligent
Cruise Control system. If the light blinks
while the engine is running, it may indi-
cate the Intelligent Cruise Control system
is not functioning properly. Have the
system checked by an INFINITI dealer.
Lane Departure Warning
(LDW) system indicator light
(Orange; if so equipped)
The light will blink if the vehicle is travel-
ing close to either the left or the right of
the traveling lane.
The light illuminates if there is a malfunc-
tion in the Lane Departure Warning (LDW)
system. See “Lane Departure Warning
(LDW) system” in the “5. Starting and
driving” section.
Malfunction indicator light
(MIL)
If the malfunction indicator light comes
on steady or blinks while the engine is
running, it may indicate a potential emis-
sion control malfunction.
The malfunction indicator light may also
come on steady if the fuel-filler cap is
loose or missing, or if the vehicle runs out
of fuel. Check to make sure the fuel-filler
cap is installed and closed tightly, and
that the vehicle has at least three gallons
of fuel in the fuel tank.
After a few driving trips, the
light
should turn off if no other potential emis-
sion control system malfunction exists.
If this indicator light comes on steady for 20
seconds and then blinks for 10 seconds
when the engine is not running, it indicates
that the vehicle is not ready for an emission
control system inspection/maintenance test.
See “Readiness for inspection/maintenance
(I/M) test” in the “9. Technical and con-
sumer information” section of this manual.
Operation
The malfunction indicator light will come
on in one of two ways:
O
Malfunction indicator light on steady
— An emission control system mal-
function has been detected. Check the
fuel-filler cap. If the fuel-filler cap is
loose or missing, tighten or install the
cap and continue to drive the vehicle.
The
light should turn off after a
few driving trips. If the
light does
not turn off after a few driving trips,
have the vehicle inspected by an
INFINITI dealer. You do not need to
have your vehicle towed to the dealer.
O
Malfunction indicator light blinking —
An engine misfire has been detected
which may damage the emission con-
trol system. To reduce or avoid emis-
sion control system damage:
2-16
Instruments and controls
w
06.6.26/S50-D/V5.0
X