![background image](/i/infiniti/147943/infiniti-fx35-2007-fx45-2007/h/infiniti-fx35-2007-fx45-2007-034.png)
CHILD RESTRAINT INSTALLATION
USING LATCH
WARNING
O
Attach LATCH compatible child re-
straints only at the locations shown. For
the LATCH lower anchor locations, see
“Lower Anchors and Tethers for CHildren
System (LATCH)” in this section. If a
child restraint is not secured properly,
your child could be seriously injured or
killed in an accident.
O
The LATCH anchors are designed to
withstand only those loads imposed by
correctly fitted child restraints. Under no
circumstance are they to be used for
adult seat belts or harnesses.
O
Inspect the lower anchors by inserting
your fingers into the lower anchor area
and feeling to make sure there are no ob-
structions over the LATCH anchors, such
as seat belt webbing or seat cushion ma-
terial. The child restraint will not be se-
cured properly if the LATCH anchors are
obstructed.
Front-facing
Follow these steps to install a front-facing
child restraint using LATCH:
1. Adjust the seatback so that it is up-
right.
O
Do not move the rear seatbacks with
the child restraints attached to them.
2. Position the child restraint on the
seat. Always follow the child restraint
manufacturer’s instructions.
3. Secure the child restraint anchor at-
tachments to the LATCH lower an-
chors.
4. The back of the child restraint should
be secured against the vehicle seat-
back. If necessary, adjust or remove
the head restraint to obtain the cor-
rect child restraint fit. See “Head re-
straint adjustment” in this section.
When the head restraint is removed,
store it in a secure place. Be sure to
install the head restraint when the
child restraint is removed.
SSS0645
Front facing — step 3
SSS0646
Front facing — step 3
1-24
Safety — Seats, seat belts and supplemental restraint system
w
06.6.26/S50-D/V5.0
X