![background image](/i/infiniti/147943/infiniti-fx35-2007-fx45-2007/h/infiniti-fx35-2007-fx45-2007-359.png)
Use the following steps to mount the li-
cense plate:
Before mounting the license plate, con-
firm that the following parts are enclosed
in the vinyl bag.
O
License plate bracket
O
J-nut x 2
O
Screw x 2
O
Screw grommet x 2
1. Temporarily place the license plate
bracket
q
1
while aligning part
q
2
of
the front bumper with part
q
3
of the
rear surface of the license plate
bracket.
2. To determine where to drill the hole,
mark
along
both
sides
of
the
mounting hole by using a felt-tip pen
q
4
.
3. Remove the license plate bracket and
connect the arcs to form ovals. Mark
the point in the center of each oval.
These are the pilot drilling locations.
4. Carefully drill two pilot holes using a
0.39 in (10 mm) drill bit at the marked
locations
q
5
.
(Be sure that the drill
only goes through the fascia, or
damage to the nut may occur.)
5. Insert grommets
q
6
into the hole on
the fascia.
6. Insert a flat-blade screwdriver
q
7
into
the grommet hole to turn the threaded
part of the grommet 90°
q
8
.
7. Insert a J-nut
q
9
into the license plate
bracket before placing the license
plate bracket on the fascia.
STI0407
INSTALLING FRONT LICENSE PLATE
Technical and consumer information
9-13
w
06.6.26/S50-D/V5.0
X