Prestige 334 User’s Guide
Chapter 15 VPN Screens
178
15.15 Viewing SA Monitor
In the web configurator, click
VPN
and the
SA Monitor
tab. Use this screen to display and
manage active VPN connections.
A Security Association (SA) is the group of security settings related to a specific VPN tunnel.
This screen displays active VPN connections. Use
Refresh
to display active VPN
connections. This screen is read-only. The following table describes the labels in this tab.
Encryption Algorithm
Select
DES
or
3DES
from the drop-down list box. The Prestige's encryption
algorithm should be identical to the secure remote gateway. When DES is
used for data communications, both sender and receiver must know the same
secret key, which can be used to encrypt and decrypt the message. The DES
encryption algorithm uses a 56-bit key. Triple DES (3DES) is a variation on
DES that uses a 168-bit key. As a result, 3DES is more secure than DES. It
also requires more processing power, resulting in increased latency and
decreased throughput.
Authentication
Algorithm
Select
SHA1
or
MD5
from the drop-down list box.
MD5
(Message Digest 5)
and
SHA1
(Secure Hash Algorithm) are hash algorithms used to authenticate
packet data. The
SHA1
algorithm is generally considered stronger than
MD5
,
but is slower. Select
MD5
for minimal security and
SHA-1
for maximum
security.
Encryption Key (Only
with ESP)
With
DES
, type a unique key 8 characters long. With
3DES
, type a unique
key 24 characters long. Any characters may be used, including spaces, but
trailing spaces are truncated.
Authentication Key
Type a unique authentication key to be used by IPSec if applicable. Enter 16
characters for
MD5
authentication or 20 characters for
SHA-1
authentication.
Any characters may be used, including spaces, but trailing spaces are
truncated.
Apply
Click
Apply
to save your changes back to the Prestige.
Reset
Click
Reset
to begin configuring this screen afresh.
Table 53
Rule Setup: Manual
LABEL
DESCRIPTION
Note:
When there is outbound traffic but no inbound traffic, the
SA times out automatically after two minutes. A tunnel with no
outbound or inbound traffic is "idle" and does not timeout until
the SA lifetime period expires.See
to
have the Prestige renegotiate an IPSec SA when the SA
lifetime expires, even if there is no traffic.