Инструкция для ZYXEL P-334 EE

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Prestige 334 User’s Guide

319

Chapter 34 VPN/IPSec Setup

Content

When you select

in the

Local ID Type

field, type the IP address of your computer or

leave the field blank to have the Prestige automatically use its own IP address.
When you select

DNS

in the

Local ID Type

field, type a domain name (up to 31 char-

acters) by which to identify this Prestige.
When you select

E-mail

in the

Local ID Type

field, type an e-mail address (up to 31

characters) by which to identify this Prestige.
The domain name or e-mail address that you use in the

Content

field is used for

identification purposes only and does not need to be a real domain name or e-mail
address.

My IP Addr

Enter the IP address of your Prestige. The Prestige uses its current WAN IP address
(static or dynamic) in setting up the VPN tunnel if you leave this field as 0.0.0.0.
The VPN tunnel has to be rebuilt if this IP address changes.

Peer ID type

Press [SPACE BAR] to choose

DNS

, or

E-mail

and press [ENTER].

Select

to identify the remote IPSec router by its IP address.

Select

DNS

to identify the remote IPSec router by a domain name.

Select

E-mail

to identify the remote IPSec router by an e-mail address.

Content

When you select

in the

Peer ID Type

field, type the IP address of the computer with

which you will make the VPN connection or leave the field blank to have the Prestige
automatically use the address in the

Secure Gateway Address

field.

When you select

DNS

in the

Peer ID Type

field, type a domain name (up to 31 charac-

ters) by which to identify the remote IPSec router.
When you select

E-mail

in the

Peer ID Type

field, type an e-mail address (up to 31

characters) by which to identify the remote IPSec router.
The domain name or e-mail address that you use in the

Content

field is used for

identification purposes only and does not need to be a real domain name or e-mail
address. The domain name also does not have to match the remote router’s IP
address or what you configure in the

Secure Gateway Address

field below.

Secure
Gateway
Address

Type the IP address or the domain name (up to 31 characters) of the IPSec router with
which you’re making the VPN connection.
Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN IP address (the

Key Management

field must be set to

IKE

, see later).

Protocol

Enter 1 for ICMP, 6 for TCP, 17 for UDP, etc. 0 is the default and signifies any protocol.

Local

Local IP addresses must be static and correspond to the remote IPSec router’s config-
ured remote IP addresses.
Two active SAs cannot have the local and remote IP address(es) both the same. Two
active SAs can have the same local or remote IP address, but not both. You can
configure multiple SAs between the same local and remote IP addresses, as long as
only one is active at any time.

Addr Type This field displays

SINGLE

for a single IP address.

Local IP Addr Enter a static IP address on the LAN behind your Prestige.

Table 105

Menu 27.1.1 IPSec Setup

FIELD

DESCRIPTION