Prestige 334 User’s Guide
Appendix A Troubleshooting
330
Appendix A
Troubleshooting
This chapter covers potential problems and possible remedies. After each problem description,
some instructions are provided to help you to diagnose and to solve the problem. Please see
our included disk for further information.
Table 110
Troubleshooting
PROBLEM
CORRECTIVE ACTION
None of the LEDs turn on
when you turn on the
Prestige.
Make sure that you have the correct power adapter connected to the
Prestige and plugged in to an appropriate power source. Check all cable
connections.If the LEDs still do not turn on, you may have a hardware
problem. In this case, you should contact your local vendor.
Cannot access the Prestige
from the LAN.
Check the cable connection between the Prestige and your computer or
hub. Refer to the Rear Panel section for details. Ping the Prestige from a
LAN computer. Make sure your computer Ethernet card is installed and
functioning properly.
Cannot ping any computer
on the LAN.
If the 10/100M LAN LEDs are off, check the cable connections between
the Prestige and your LAN computers.Verify that the IP address and
subnet mask of the Prestige and the LAN computers are in the same IP
address range.
Cannot get a WAN IP
address from the ISP.
The WAN IP is provided after the ISP verifies the MAC address, host
name or user ID.Find out the verification method used by your ISP and
configure the corresponding fields.
If the ISP checks the WAN MAC address, you should clone the MAC
address from a LAN computer. Click WAN and then the MAC tab, select
Spoof this Computer's MAC address - IP Address and enter the IP
address of the computer on the LAN whose MAC address you are
cloning.
If the ISP checks the host name, enter your computer’s name (refer to the
Wizard Setup section in the User’s Guide) in the System Name field in the
first screen of the WIZARD.
If the ISP checks the user ID, click WAN and then the ISP tab. Check your
service type, user name, and password.
Cannot access the Internet. Check the Prestige’s connection to the cable/DSL device.
Check whether your cable/DSL device requires a crossover or straight-
through cable.
Click WAN to verify your settings.
Access to a restricted web
page is not blocked.
Make sure that the Enable Parental Control check box is selected in the
Parental Control screen.
Make sure that you select a category in the Parental Control screen to
restrict access to web pages relevant to that category. For example,
select the Gambling check box to prevent access to
www.onlinegambling.com.
Make sure that the Blocking Schedule configured in the Parental Control
screen restricts access at the scheduled time.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
284
285
286
287
288
289
290
291
292
293
294
295
296
297
298
299
300
301
302
303
304
305
306
307
308
309
310
311
312
313
314
315
316
317
318
319
320
321
322
323
324
325
326
327
328
329
330
331
332
333
334
335
336
337
338
339
340
341
342
343
344
345
346
347
348
349
350
351
352
353
354
355
356
357
358
359
360
361
362
363
364
365
366
