Prestige 334 User’s Guide
39
Chapter 2 Introducing the Web Configurator
Figure 3
Change Password Screen
You should now see the
MAIN MENU
screen)
2.3 Resetting the Prestige
If you forget your password or cannot access the web configurator, you will need to use the
RESET
button at the back of the Prestige to reload the factory-default configuration file. This
means that you will lose all configurations that you had previously and the password will be
reset to “1234”.
2.3.1 Procedure To Use The Reset Button
1
Make sure the
PWR
LED is on (not blinking).
2
Press the
RESET
button for ten seconds or until the
PWR
LED begins to blink and then
release it. When the
PWR
LED begins to blink, the defaults have been restored and the
Prestige restarts.
2.3.2 Navigating the Prestige Web Configurator
The following summarizes how to navigate the web configurator from the
SITE MAP
screen.
• Click
WIZARD
for initial configuration including general setup, ISP parameters for
Internet Access and WAN IP/DNS Server/MAC address assignment.
• Click a link under
ADVANCED
to configure advanced Prestige features.
Note:
The management session automatically times out when
the time period set in the Administrator Inactivity Timer field
expires (default five minutes). Simply log back into the Prestige
if this happens to you