Prestige 334 User’s Guide
Chapter 23 Remote Node Configuration
224
C
H A P T E R
23
Remote Node Configuration
This chapter covers remote node configuration.
23.1 Introduction to Remote Node Setup
A remote node is required for placing calls to a remote gateway. A remote node represents
both the remote gateway and the network behind it across a WAN connection. Note that when
you use menu 4 to set up Internet access, you are actually configuring a remote node. The
following describes how to configure
Menu 11.1 Remote Node Profile
,
Menu 11.3 - Remote
Node Network Layer Options
,
Menu 11.5 - Remote Node Filter
and
Menu 11.6 - Traffic
Redirect Setup
.
23.2 Remote Node Profile Setup
From the main menu, select menu option 11 to open
Menu 11 Remote Node Profile
(shown
below).
The following explains how to configure the remote node profile menu.
23.2.1 Ethernet Encapsulation
There are two variations of menu 11 depending on whether you choose
Ethernet
Encapsulation
or
PPPoE
Encapsulation.
You must choose the
Ethernet
option when the
WAN port is used as a regular Ethernet. The first menu 11.1 screen you see is for Ethernet
encapsulation shown next.