Prestige 334 User’s Guide
Chapter 31 System Maintenance
298
C
H A P T E R
31
System Maintenance
This chapter leads you through SMT menus 24.8 to 24.10.
31.1 Command Interpreter Mode
The Command Interpreter (CI) is a part of the main system firmware. The CI provides much of
the same functionality as the SMT, while adding some low-level setup and diagnostic
functions. Enter the CI from the SMT by selecting menu 24.8. See the included disk or the
zyxel.com web site for more detailed information on CI commands. Enter 8 from
Menu 24 —
System Maintenance
. A list of valid commands can be found by typing
help
or
?
at the
command prompt. Type “exit” to return to the SMT main menu when finished.
Figure 165
Command Mode in Menu 24
31.1.1 Command Syntax
• The command keywords are in
courier new
font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets
<>
.
• The optional fields in a command are enclosed in square brackets
[]
.
• The
|
symbol means “or”.
• For example,
• sys filter netbios config <type> <on|off>
• means that you must specify the type of netbios filter and whether to turn it on or off.
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Firmware Update
8. Command Interpreter Mode
9. Call Control
10. Time and Date Setting
11. Remote Management Setup
Enter Menu Selection Number: