Prestige 334 User’s Guide
Chapter 23 Remote Node Configuration
226
23.2.2 PPPoE Encapsulation
The Prestige supports PPPoE (Point-to-Point Protocol over Ethernet). You can only use
PPPoE encapsulation when you’re using the Prestige with a DSL modem as the WAN device.
If you change the Encapsulation to
PPPoE,
then you will see the next screen. Please see the
appendix
for more information on PPPoE.
Figure 103
Menu 11.1 Remote Node Profile for PPPoE Encapsulation
23.2.2.1 Outgoing Authentication Protocol
Generally speaking, you should employ the strongest authentication protocol possible, for
obvious reasons. However, some vendor’s implementation includes a specific authentication
protocol in the user profile. It will disconnect if the negotiated protocol is different from that in
the user profile, even when the negotiated protocol is stronger than specified. If you encounter
a case where the peer disconnects right after a successful authentication, please make sure that
you specify the correct authentication protocol when connecting to such an implementation.
Edit IP
This field leads to a “hidden” menu. Press [SPACE BAR] to select
Yes
and press
[ENTER] to go to
Menu 11.3 - Remote Node Network Layer Options
.
Session Options
Edit Filter Sets
This field leads to another “hidden” menu. Use [SPACE BAR] to select
Yes
and
press [ENTER] to open menu 11.5 to edit the filter sets. See the
Remote Node
Filter
section for more details.
Edit Traffic
Redirect
Press [SPACE BAR] to select
Yes
or
No
.
Select
Yes
and press [ENTER] to configure
Menu 11.6 Traffic
Redirect Setup
.
Select
No
(default) if you do not want to configure this feature.
Once you have configured this menu, press [ENTER] at the message “Press ENTER to Confirm...” to
save your configuration, or press [ESC] at any time to cancel.
Table 74
Menu 11.1 Remote Node Profile for Ethernet Encapsulation
FIELD
DESCRIPTION
Menu 11.1 - Remote Node Profile
Rem Node Name= MyISP Route= IP
Active= Yes
Encapsulation= PPPoE Edit IP= No
Service Type= Standard Telco Option:
Service Name= Allocated Budget(min)= 0
Outgoing: Period(hr)= 0
My Login= Schedules=
My Password= ******** Nailed-Up Connection= No
Retype to Confirm= ********
Authen= CHAP/PAP
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Edit Traffic Redirect= No
Press ENTER to Confirm or ESC to Cancel: