Prestige 334 User’s Guide
Chapter 34 VPN/IPSec Setup
320
Port Start 0 is the default and signifies any port. Type a port number from 0 to 65535. You cannot
create a VPN tunnel if you try to connect using a port number that does not match this
port number or range of port numbers.
Some of the most common IP ports are: 21, FTP; 53, DNS; 23, Telnet; 80, HTTP; 25,
SMTP; 110, POP3
End Enter a port number in this field to define a port range. This port number must be
greater than that specified in the previous field. This field is
N/A
when 0 is configured in
the
Port Start
field.
Remote
Remote IP addresses must be static and correspond to the remote IPSec router’s con-
figured local IP addresses. The remote fields are
N/A
when the
Secure Gateway
Address
field is configured to 0.0.0.0.
Two active SAs cannot have the local and remote IP address(es) both the same. Two
active SAs can have the same local or remote IP address, but not both. You can
configure multiple SAs between the same local and remote IP addresses, as long as
only one is active at any time.
Addr Type Press [SPACE BAR] to choose
SINGLE
,
RANGE
, or
SUBNET
and press [ENTER].
Select
SINGLE
with a single IP address. Use
RANGE
for a specific range of IP
addresses. Use
SUBNET
to specify IP addresses on a network by their subnet mask.
IP Addr Start When the
Addr Type
field is configured to
Single
, enter a static IP address on the net-
work behind the remote IPSec router.
When the
Addr Type
field is configured to
Range
, enter the beginning (static) IP
address, in a range of computers on the network behind the remote IPSec router.
When the
Addr Type
field is configured to
SUBNET
, enter a static IP address on the
network behind the remote IPSec router.
This field displays
N/A
when you configure the
Secure Gateway Address
field to
0.0.0.0.
End/Subnet
Mask
When the
Addr Type
field is configured to
Single
, this field is
N/A
.
When the
Addr Type
field is configured to
Range
, enter the end (static) IP address, in
a range of computers on the network behind the remote IPSec router.
When the
Addr Type
field is configured to
SUBNET
, enter a subnet mask on the net-
work behind the remote IPSec router.
This field displays
N/A
when you configure the
Secure Gateway Address
field to
0.0.0.0.
Port Start 0 is the default and signifies any port. Type a port number from 0 to 65535. Someone
behind the remote IPSec router cannot create a VPN tunnel when attempting to con-
nect using a port number that does not match this port number or range of port num-
bers.
Some of the most common IP ports are: 21, FTP; 53, DNS; 23, Telnet; 80, HTTP; 25,
SMTP; 110, POP3.
End Enter a port number in this field to define a port range. This port number must be
greater than that specified in the previous field. This field is
N/A
when 0 is configured in
the
Port Start
field.
Table 105
Menu 27.1.1 IPSec Setup
FIELD
DESCRIPTION