Prestige 334 User’s Guide
Chapter 25 Network Address Translation (NAT)
242
Now if you delete rule 4, rules 5 to 7 will be pushed up by 1 rule, so as old rule 5 becomes rule
4, old rule 6 becomes rule 5 and old rule 7 becomes rule 6.
Selecting
Edit
in the
Action
field and then selecting a rule brings up the following menu,
Menu 15.1.1.1
- Address Mapping Rule
in which you can edit an individual rule and
configure the
Type
,
Local
and
Global Start/End IPs
.
Table 82
Menu 15.1.1 First Set
FIELD
DESCRIPTION
Set Name
Enter a name for this set of rules. This is a required field. If this field is left blank, the
entire set will be deleted.
Action
The default is
Edit
.
Edit
means you want to edit a selected rule (see following field).
Insert Before
means to insert a rule before the rule selected. The rules after the
selected rule will then be moved down by one rule.
Delete
means to delete the
selected rule and then all the rules after the selected one will be advanced one rule.
None
disables the
Select Rule
item.
Select Rule
When you choose
Edit
,
Insert Before
or
Delete
in the previous field the cursor jumps
to this field to allow you to select the rule to apply the action in question.
Note:
You must press [ENTER] at the bottom of the screen to
save the whole set. You must do this again if you make any
changes to the set – including deleting a rule. No changes to
the set take place until this action is taken
Note:
An End IP address must be numerically greater than its
corresponding IP Start address