Appendix A: Line 6 Monkey

A•3

As an example, the above screenshot shows Monkey has detected that a newer Firmware - 

Flash Memory version is available than is currently installed in our device. In this scenario 

you can select the Flash Memory item and click 

Update Selection

. Be sure to read the 

prompts carefully and Monkey will assist you in performing the update in minutes. It is 

especially important not to disturb the devices’ controls and cable connections until the 

update fully completes!

Flash Memory Updates and Presets

Flash Memory updates typically include a complete set of Factory Presets, which may be a 

revised set that differs from the set of Presets stored in the memory of your device. You’ll 

be prompted during the update whether to keep your current Presets. Selecting “No” will 

result in your device’s Presets being permanently overwritten.

The prompt during a Flash Memory update to keep your current Presets

TIP! You can save the full set of your device’s Presets as a “Bundle” file to your computer in 
one easy step using POD HD Pro Edit - see 

“POD HD Edit Pro Software” on page 1•6

.

ENTER

DBL PRESS TO ASSIGN CTL

MOVE

AMP & FX   ON / OFF

Once a Flash Memory update is complete, it is recommended that you power 

on POD HD Pro while holding down the Nav. Pad - left arrow button. This 

performs a “reset” of all global settings to their factory defaults. This reset 

also updates your device’s Set List titles with those included in the new 

Flash Memory version (if they differ).