![background image](/i/line-6/137211/line-6-pod-hd-pro/h/line-6-pod-hd-pro-089.png)
USB Audio
9•3
The POD HD Pro Record Send
As shown above, the Record Send is the virtual “pipeline” that carries your POD HD-
processed, 24-bit digital signal across the USB connection, making it available to your
audio software as an input signal for recording.
The Record Send appears as an available audio input/recording device within your audio
software.
Simply select this Send as the input for your audio track and you’ll be able to
record your POD HD Pro signal. The level of the signal fed to the Send is affected by your
POD HD Pro controls: Mixer block Volume A & B, Amp Model Drive & Volume, FX
Model Gain controls, Volume Pedal, etc., (but
not
the Master Volume knob). For the best
recording quality, watch the input meters provided in your software and adjust your level
to be at least halfway up, but never “clipping.”
Note that the type of audio signal fed to the Record Sends is controlled by the
Output
Mode
setting found in the
POD HD Pro Setup:Outputs
screen. For most USB recording
situations, you’ll likely want to set this to “Studio/Direct.” Please see
for more info.
The Line 6 Audio-MIDI Devices Panel
The Line 6 Audio-MIDI Devices utility is the place where you configure various audio
driver settings. The options in the Line 6 Audio-MIDI Devices dialog are slightly different
if you are on a Mac® versus a Windows® system. See the following descriptions that
match your setup: For Mac® see next section, or for Windows® see