Appendix B: FBV Foot Controllers
B•20
•
If a footswitch already has an Amp or FX Block assigned:
The existing Block remains
assigned, and selecting this footswitch
additionally assigns your new Block. When
referencing the Performance View, you’ll see the footswitch display a “Multi” graphic
to indicate this. You can configure 2 or more parameters to the same footswitch to
toggle them On/Off simultaneously - or, have one toggle On while another Toggles
Off!
Indicates multiple Blocks assigned to a footswitch
TIP: To reference current footswitch assignments, when in the Footswitch Assign screen,
use the
Nav. Pad buttons to select each Block, and look at the Knob 1 setting for each
at the bottom of the screen.
•
When a footswitch has no Block assigned:
You’ll see the N/A graphic displayed in
the Performance View for the respective footswitch.
Indicates no Blocks assigned to the footswitch
Using the EXP Pedal Toe Switch
As noted above, when adding a Wah or Volume/Pan Model to your tone, their Position
parameters are automatically assigned to the
EXP 1
and
EXP 2
controllers. Most Factory
Presets already include this Wah/Volume switching pre-configured for you. But the Toe
Switch assignment is not set automatically for newly added Amp or FX Models, so here is
how to set this up manually.
• With the Wah Model selected, go to the
FS Assign
screen and assign its FX Block to
the
EXP TOE SWITCH
, following the instructions above. This allows the Wah to
be toggled On/Off via the pedal Toe Switch.