![background image](/i/line-6/137211/line-6-pod-hd-pro/h/line-6-pod-hd-pro-059.png)
Amp, Cab & Mic Models
6•11
Amp Edit - Page 5
Here you’ll find even further “deep-editing” parameters for the Speaker Cab, allowing you
to surgically refine the the feel and frequency response to your personal taste.
•
Knob 1
: Adjusts the overall level of the modeled speaker Resonance, which results
in a more “lively,” brighter response on higher settings. Increasing the Resonance
Level will cause the overall volume to increase as well.
•
Knob 2
: Adjusts the low frequency level of the modeled speaker resonance. Just as
the name implies, increasing the value on this knob adds more low end “Thump” to
the Cab tone.
•
Knob 3
: Adjusts the Decay time of the modeled speaker resonance. This control
provides the feel of a “tighter” speaker cone at lower values and a “looser” speaker
at higher values.
Note: The above three Cab parameters are interactive - As the Resonance Level is decreased
so are the effects of the Thump and Decay parameters. Thump and Decay are applied to
the modeled speaker resonance, therefore, if the Resonance Level is set to a minimum, the
effects of Thump and Decay parameters will not be audible.
Resonance Level, Thump, and Decay controls will only be audible when the POD is in
Studio/Direct output mode.