![background image](/i/line-6/137211/line-6-pod-hd-pro/h/line-6-pod-hd-pro-123.png)
Appendix B: FBV Foot Controllers
B•21
Assigning an FX Block to the on-board pedal’s “Toe Switch”
Further, if you have a different FX parameter (such as the Volume - Position) being
controlled by the opposite EXP Pedal Mode, you’ll likely find it useful to have the Toe
Switch toggle both these FX Blocks On/Off alternately, so that only the desired Model
is active while being controlled. For example, say you have a Preset where the Wah is
controlled by
EXP 1
, and the Volume by
EXP 2
:
Note: If you have a “Pedal 2” connected to your FBV (or if using an FBV Longboard) you
may
not
want to use the following configuration, since the Wah and Volume are already
controlled by your two Pedals individually.
• Click the
EXP TOE SWITCH
switch so that the red
EXP 1
LED is lit.
• In the Signal Flow View, select the Volume FX block and toggle it “Off” using the
ENTER
button. You should now see the Wah “On” and the Volume “Off.”
Wah in “On” Volume is “Off”
• Repeat the previous Footswitch Assign steps for both the Wah and the Volume,
assigning each to the
EXP TOE SWITCH
.
• Now whenever you click the
EXP TOE SWITCH
to
EXP 1
for this Preset, the
Volume is switched “Off” and the Wah is switch “On” and is controlled by the Pedal
- and vice versa when switching to
EXP 2
.
• Be sure to save to retain these settings with your Preset!