Using the Looper

8•5

• 

Playback (Knob 1) -

  Use  Multi-function  Knob  1  to  adjust  the  Looper  playback 

volume. You may find it useful to turn this down a bit so that your live guitar can be 

slightly louder.

• 

Overdub (Knob 2) -

  Use  Multi-function  Knob  2  to  adjust  the  level  at  which  all 

Overdubs are recorded. This level does not affect the level of your original Loop 

recording.

• 

Hi Cut (Knob 3) & Lo Cut (Knob 4) -

 Use Multi-function Knobs 3 & 4 to adjust 

these EQ options, to reduce the treble and bass of your Loop playback. It can be 

helpful to reduce these to optimize the “mix” of your Loop playback with your live 

guitar. These controls reduce the High and Low frequencies more as you raise their 

values.

1/2 Speed Operation

The Looper utilizes both the 1/2 Speed and Full Speed options for recording and playback. 

These options directly affect the maximum Loop recording time.

POD HD Looper Record Time

Full Speed

24 Seconds maximum

1/2 Speed

48 Seconds maximum

Specific behaviors apply, as follows:

• 

Full Speed:

 When set to 

Full Speed

 before recording, the Looper provides up to 24 

seconds max. recording time. 

•  Playback of the recorded Loop at the 

Full Speed

 setting is heard just as recorded. 

•  If you change the setting to 

1/2 Speed

, your recorded Loop is played back at half 

speed, as well as pitched one octave lower.

• 

1/2 Speed:

 When set to 

1/2 Speed

 before recording, the Looper provides up to 48 

seconds maximum recording time.

•  Playback of the recorded Loop at the 

1/2 Speed

 setting is heard just as recorded. 

•  If you change the setting to 

Full Speed

, your recorded Loop is played back at 

double speed, as well as pitched one octave higher.