Features & Functionality
3•5
Moving FX Blocks
Any of the 8 FX Blocks can be moved throughout your tone’s signal flow, providing
tremendous routing flexibility. To move any FX Block, start within the Signal Flow View
and select the FX Block to be moved. Press the
MOVE
button and you’ll see the selected
FX Block appear “raised” to indicate it is now moveable.
ENTER
DBL PRESS TO ASSIGN CTL
MOVE
AMP & FX ON / OFF
Pressing the Move button to reposition an FX Block
The FX Block can now be moved as follows:
• Use the
Nav. Pad buttons to move the FX Block to the desired position.
• Move the FX Block into either Path A or B, and place it before or after an Amp
Model within the path. Use the Nav. Pad buttons to move the FX Block to
the opposite path. This allows you to run your effect in “parallel” and blend the
individual Path A & B outputs using the Mixer’s Level & Pan options!
• Once the FX Block is in the desired position, press the
MOVE
button again to drop
it into place.
• Amp Blocks can be moved into fixed positions within the Pre or Post signal path
areas, or within the Paths A & B - see
“Amp Model Positioning” on page 6•1
• The Looper can also be selected and moved either to the start (“Pre”) or end (“Post”)
.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
