![background image](/i/zyxel/144701/zyxel-zywall-2wg-ee/h/zyxel-zywall-2wg-ee-542.png)
Chapter 31 WAN and Dial Backup Setup
ZyWALL 2WG User’s Guide
542
The following table describes the fields in this screen.
31.3 Dial Backup
The Dial Backup port can be used in reserve, as a traditional dial-up connection should the
broadband connection to the WAN port fail. To set up the auxiliary port (Dial Backup) for use
in the event that the regular WAN connection is dropped, first make sure you have set up the
switch and port connection (see the Quick Start Guide), then configure
1
Menu 2 - WAN Setup,
2
Menu 2.1 - Advanced WAN Setup and
3
Menu 11.3 - Remote Node Profile (Backup ISP)
Refer also to the section
about traffic redirect for information on an alternate backup WAN
connection.
31.3.1 Configuring Dial Backup in Menu 2
From the main menu, enter 2 to open menu 2.
Table 199
MAC Address Cloning in WAN Setup
FIELD
DESCRIPTION
WAN 1 MAC
Address
Assigned By
Press [SPACE BAR] and then [ENTER] to choose one of two methods to assign a
MAC Address. Choose
Factory Default
to select the factory assigned default MAC
Address. Choose
IP address attached on LAN
to use the MAC Address of that
computer whose IP you give in the following field.
IP Address
This field is applicable only if you choose the
IP address attached on LAN
method
in the
Assigned By
field. Enter the IP address of the computer on the LAN whose
MAC you are cloning.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to
save your configuration, or press [ESC] at any time to cancel.