![background image](/i/zyxel/144701/zyxel-zywall-2wg-ee/h/zyxel-zywall-2wg-ee-585.png)
Chapter 37 Remote Node Setup
ZyWALL 2WG User’s Guide
585
37.5 Remote Node Filter
Move the cursor to the field
Edit Filter Sets
in menu 11.1, and then press
[SPACE BAR]
to
set the value to
Yes
. Press
[ENTER]
to open
Menu 11.1.4 - Remote Node Filter
.
Use
menu 11.1.4 to specify the filter set(s) to apply to the incoming and outgoing traffic
between this remote node and the ZyWALL to prevent certain packets from triggering calls.
You can specify up to 4 filter sets separated by commas, for example, 1, 5, 9, 12, in each filter
field. Note that spaces are accepted in this field. For more information on defining the filters,
please refer to
PPPoE or PPTP encapsulation, you have the
additional option of specifying remote node call filter sets.
NAT Lookup
Set
If you select
SUA Only
in the
Network Address Translation
field, it displays
255
and
indicates
the SMT will use the pre-configured
Set 255
(read only) in menu 15.1.
If you select
Full Feature
or
None
in the
Network Address Translation
field, it
displays
1
,
2
or
3
and indicates
the SMT will use the pre-configured
Set 1
in menu
15.1 for the first WAN port,
Set 2
in menu 15.1 for the second WAN port and
Set 3
for
the Backup port.
Refer to
for more information.
Metric
Enter a number from 1 to 15 to set this route’s priority among the ZyWALL’s routes
). The smaller the number, the higher priority the route has.
Private
This field is valid only for PPTP/PPPoE encapsulation. This parameter determines if
the ZyWALL will include the route to this remote node in its RIP broadcasts. If set to
Yes
, this route is kept private and not included in RIP broadcast. If
No
, the route to this
remote node will be propagated to other hosts through RIP broadcasts.
RIP Direction
Press [SPACE BAR] and then [ENTER] to select the RIP direction from
Both
/
None
/
In
Only
/
Out Only
. See
for more information on RIP. The default
for RIP on the WAN side is
None
. It is recommended that you do not change this
setting.
Version
Press [SPACE BAR] and then [ENTER] to select the RIP version from
RIP-1
/
RIP-2B
/
RIP-2M
or
None
.
Multicast
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to establish
membership in a Multicast group. The ZyWALL supports both IGMP version 1 (
IGMP-
v1
) and version 2 (
IGMP-v2)
. Press [SPACE BAR] to enable IP Multicasting or select
None
to disable it. See
for more information on this feature.
Once you have completed filling in
Menu 11.3 Remote Node Network Layer Options
, press [ENTER]
at the message “Press ENTER to Confirm...” to save your configuration and return to menu 11, or
press [ESC] at any time to cancel.
Table 220
Remote Node Network Layer Options Menu Fields (continued)
FIELD
DESCRIPTION