Chapter 2 Introducing the Web Configurator
ZyWALL 2WG User’s Guide
63
3G Card ESN
This field is available only when you insert a CDMA (Code Division Multiple
Access) 3G card.
This shows the ESN (Electronic Serial Number) of the inserted CDMA 3G card.
The ESN is the serial number of a CDMA 3G card and is similar to the IMEI on a
GSM or UMTS 3G card.
Enter PIN code
again
If the PIN code you specified in the
WAN 2
screen is not the right one for the card
you inserted, this field displays allowing you to enter the correct PIN code. Enter
the PIN code (four to eight digits) for the inserted 3G card.
Apply
Click
Apply
to save the correct PIN code and replace the one you specified in the
WAN 2
screen.
PUK Code
If you enter the PIN code incorrectly three times, the SIM card will be blocked by
your ISP and you cannot use the account to access the Internet. You should get
the PUK (Personal Unblocking Key) code (four to eight digits) from your ISP.
Enter the PUK code to enable the SIM card. If an incorrect PUK code is entered
10 times, the SIM card will be disabled permanently. You then need to contact
your ISP for a new SIM card.
New PIN Code
Configure a PIN code for the SIM card. You can specify any four to eight digits to
have a new PIN code or enter the previous PIN code.
Confirm New PIN
Code
Enter the PIN code again for confirmation.
Apply
Click
Apply
to save your changes in this section.
Reset budget
counters, resume
budget control
This field displays if you have enabled budget control but insert a 3G card with a
different user account from the one for which you configured budget control.
Select this option to have the ZyWALL do budget calculation starting from 0 but
use the previous settings.
Resume budget
control
This field displays if you have enabled budget control but insert a 3G card with a
different user account from the one for which you configured budget control.
Select this option to have the ZyWALL keep the existing statistics and continue
counting.
Disable budget
control
This field displays if you have enabled budget control but insert a 3G card with a
different user account from the one for which you configured budget control.
Select this option to disable budget control.
If you want to enable and configure new budget control settings for the new user
account, go to the
WAN 2
screen.
The ZyWALL keeps the existing statistics if you do not change the budget control
settings. You could reinsert the original card and enable budget control to have
the ZyWALL continue counting the budget control statistics.
Apply
Click
Apply
to save your changes in this section.
Enter modem
unlock code
This field only displays when you insert a 3G card and the internal modem on the
3G card is blocked.
Enter a key to enable the internal modem on your 3G card. By default, the key is
the last four digits of your phone number used to dial up the 3G connection.
Otherwise, you need to get the key from your service provider.
Apply
Click
Apply
to save your changes in this section.
Remaining Time
Budget
This field is available only when you enable budget control in the
3G (WAN 2)
screen.
This shows the amount of time (in hours and minutes) the 3G connection can still
be used before the ZyWALL takes the actions you specified in the
3G (WAN 2)
screen.
Table 3
Web Configurator HOME Screen in Router Mode (continued)
LABEL
DESCRIPTION