![background image](/i/zyxel/144701/zyxel-zywall-2wg-ee/h/zyxel-zywall-2wg-ee-672.png)
Chapter 47 IP Policy Routing
ZyWALL 2WG User’s Guide
672
47.2.1 Applying Policy to Packets
To apply the policy to packets received on the selected interface(s), go to
Menu 25.1: IP
Routing Policy Setup
and press [SPACE BAR] to select
Yes
in the
Edit policy to packets
received from
field. Press [ENTER] to display
Menu 25.1.1 - IP Routing Policy Setup
(shown next).
addr start / end
Destination IP address range from start to end.
port start / end
Destination port number range from start to end; applicable only for TCP/UDP.
Action
Specifies whether action should be taken on criteria Matched or Not Matched.
Gateway Type
Press [SPACE BAR] and then [ENTER] to select
IP Address
and enter the IP
address of the gateway if you want to specify the IP address of the gateway. The
gateway is an immediate neighbor of your ZyWALL that will forward the packet to
the destination. The gateway must be a router on the same segment as your
ZyWALL's LAN or WAN port.
Press [SPACE BAR] and then [ENTER] to select
Remote Node
to have the
ZyWALL send traffic that matches the policy route through a specific WAN port.
Gateway addr
This field displays if you selected
IP Address
in the
Gateway Type
field. Defines
the outgoing gateway address. The gateway must be on the same subnet as the
ZyWALL if it is on the LAN, otherwise, the gateway must be the IP address of a
remote node. The default gateway is specified as 0.0.0.0.
Remote Node Idx
This field displays if you selected
Remote Node
in the
Gateway Type
field. Type
1
for WAN port 1 or
2
for WAN port 2.
Redirect Packet
This field applies if you selected
Remote Node
in the
Gateway Type
field.
Press [SPACE BAR] and then [ENTER] to select
Yes
to have the ZyWALL send
traffic that matches the policy route through the other WAN interface if it cannot
send the traffic through the WAN interface you selected.
Type of Service
Set the new TOS value of the outgoing packet. Prioritize incoming network traffic
by choosing
Don't Care
,
Normal
,
Min Delay
,
Max Thruput
,
Max Reliable
or
Min
Cost
.
Precedence
Set the new outgoing packet precedence value. Values are
0
to
7
or
Don't Care
.
Log
Press [SPACE BAR] and then [ENTER] to select
Yes
to make an entry in the
system log when a policy is executed.
Edit policy to
packets received
from
Press [SPACE BAR] and then [ENTER] to select
Yes
or
No
(default). Select
Yes
to configure Menu 25.1.1: IP Routing Policy Setup discussed next.
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or
[ESC] to cancel" to save your configuration or press [ESC] to cancel and go back to the previous
screen.
Table 248
Menu 25.1: IP Routing Policy Setup
FIELD
DESCRIPTION