![background image](/i/zyxel/144701/zyxel-zywall-2wg-ee/h/zyxel-zywall-2wg-ee-579.png)
ZyWALL 2WG User’s Guide
579
C
H A P T E R
37
Remote Node Setup
This chapter shows you how to configure a remote node.
37.1 Introduction to Remote Node Setup
A remote node is required for placing calls to a remote gateway. A remote node represents
both the remote gateway and the network behind it across a WAN connection. Note that when
you use menu 4 to set up Internet access, you are actually configuring a remote node. The
following describes how to configure
Menu 11.1 - Remote Node Profile
,
Menu 11.1.2 -
Remote Node Network Layer Options
and
Menu 11.1.4 - Remote Node Filter
.
37.2 Remote Node Setup
From the main menu, select menu option 11 to open
Menu 11 - Remote Node Setup
(shown
below).
Enter
1
to open
Menu 11.1 - Remote Node Profile
and configure the setup for your WAN
port. Enter
2
to open
Menu 11.2 - Remote Node Profile (3G WAN)
and configure the setup
for your 3G connection. Enter
3
to open
Menu 11.3 Remote Node Profile (Backup ISP)
and
configure the setup for your Dial Backup port connection (see
).
Figure 366
Menu 11: Remote Node Setup
37.3 Remote Node Profile Setup
The following explains how to configure the remote node profile menu. Not all fields are
available on all models.
Menu 11 - Remote Node Setup
1. WAN_1 (ISP, SUA)
2. WAN_2 (ISP, SUA)
3. -Dial (BACKUP_ISP, SUA)
Enter Node # to Edit: