How to Attach the Charged Battery

Pack

If you attach an exhausted Battery Pack, the “ [XJ ”
Indication on the LCD Monitor or in the Viewfinder

flashes.

1

  Attach the Battery Pack with its upper part

(the end with the Charge Confirmation

Marker) into the upper Battery Pack Hoider.

2

  Press the iower part of the Battery Pack

toward the Movie Camera until it locks with

a click.

■ Removing the Battery Pack

Notes:
1.  Never remove the Battery Pack during recording or 

piayback, because the tape would remain in contact 
with the video heads and this could cause damage to 

the heads and tape.

2.  When sliding the [BATTERY EJECT ►] Lever, be 

sure to hold the Battery Pack as shown in the 
illustration above, to prevent it from dropping.

3.  After use, remove the Battery Pack from the Movie 

Camera and keep it in a cool place, if you leave the 
Battery Pack attached to the Movie Camera, a small 
amount of current flows to the Movie Camera even if 
the [POWER] Switch is turned in, and this reduces 
the Battery Pack’s charging capacity.

1

  Turn in the [POWER] Switch. (The Movie

Camera switches off.)

2

  Pull off the Battery Pack while sliding the

[BATTERY EJECT ►] Lever in the

direction of the arrow.

3

“CSJ”

Ko

■;±

j

S ;

iMsiiifflfiiS, ilHmsiTOia^jgsScffltSo

2. [fli [BATTERY EJECTS] 

^ilZ'SnJiHfifftF, }lt±

3.

gp-(i:ft[POWER]

(Slitftii) etiSttilT,

1

i]i?g)®ii [POWER] 

mm

m m ) o

2

[

battery

ejects

] m.

18