[T| How to Charge the Battery Pack

The following explanations show you how to use the 
supplied AC Adaptor for charging the Battery Pack.
The Battery Pack is a nickel-cadmium storage battery.
As it self-discharges relatively easily, it is recommended 
to charge the Battery Pack not more than one day before 
using it.
The Battery Pack's ability to generate electric energy is 
based on a chemical reaction. Because this reaction can 
take place better at high temperature, the maximum 

recording time may be considerably shorter than listed 

{-*

 16) when recording at low temperature.

Notes:

1.  When charging the Battery Pack, disconnect the DC 

Input Cable (-> 62) from the AC Adaptor.

2.  Charge the Battery Pack at a room temperature 

between 10°C and 35°C.

3.  If the operation time of the Battery Pack after 

charging is too short for practical use, the Battery 

Pack has reached the end of its service life. Replace 
it with a new one.

4.  Do not charge the Battery Pack again when it is 

already fully charged.

5.  During use on the Movie Camera and during 

charging, the Battery Pack may become warm. This is 
normal.

1

  Attach the Battery Pack.

•Align the Battery Pack with line O 3rid push it in 

the direction of the arrow while holding it down.

(To remove the Battery Pack, slide it in the 

opposite direction.)

2

  Securely connect the AC Mains Cable to

the AC Adaptor and an AC mains socket.

Hong Kong Only.

• The Power Lamp 0 lights and then the Charging 

Indication Lamp (2) lights, too.

■ Charging Indication Lamp

Lit: 

During charging

Not lit: Charging has finished. For optimum charging, 

continue charging for 2 hours after the lamp 
goes out.

2

ssaii, 

a

lit,

:

(-t62)„

2. 

~35"C„

1

CA):

14