Chapter 6 Dashboard
NXC5200 User’s Guide
105
Refresh Now (D)
Click this to update the widget’s information immediately.
Close Widget (E)
Click this to close the widget. Use Widget Setting to re-open it.
Virtual Device
The following front and rear panel labels display when you hover your
cursor over a connected interface or slot.
Status
This field displays the current status of each interface or device
installed in a slot. The possible values depend on what type of
interface it is.
Inactive - The Ethernet interface is disabled.
Down - The Ethernet interface is enabled but not connected.
Speed / Duplex - The Ethernet interface is enabled and connected.
This field displays the port speed and duplex setting (Full or Half).
HA Status
This field displays the status of the interface in the virtual router.
Active - This interface is the master interface in the virtual router.
Stand-By - This interface is a backup interface in the virtual router.
Fault - This VRRP group is not functioning in the virtual router right
now. For example, this might happen if the interface is down.
n/a - Device HA is not active on the interface.
Zone
This field displays the zone to which the interface is currently
assigned.
IP Address/
Mask
This field displays the current IP address and subnet mask assigned
to the interface. If the interface is a member of an active virtual
router, this field displays the IP address it is currently using. This is
either the static IP address of the interface (if it is the master) or the
management IP address (if it is a backup).
Device
Information
System Name
This field displays the name used to identify the NXC on any network.
Click the icon to open the screen where you can change it.
Model Name
This field displays the model name of this NXC.
Serial Number
This field displays the serial number of this NXC.
MAC Address
Range
This field displays the MAC addresses used by the NXC. Each physical
port has one MAC address. The first MAC address is assigned to
physical port 1, the second MAC address is assigned to physical port
2, and so on.
Firmware
Version
This field displays the version number and date of the firmware the
NXC is currently running. Click the icon to open the screen where you
can upload firmware.
System
Resources
CPU Usage
This field displays what percentage of the NXC’s processing capability
is currently being used. Hover your cursor over this field to display
the Show CPU Usage icon that takes you to a chart of the NXC’s
recent CPU usage.
Table 22
Dashboard (continued)
LABEL
DESCRIPTION