Chapter 4 Configuration Basics
NXC5200 User’s Guide
63
4.4.3 Licensing Update
Use these screens to update the NXC’s signature packages for the anti-virus, IDP
and application patrol features. You must have a valid subscription to update the
anti-virus and IDP/application patrol signatures. You must also have Internet
access to myZyXEL.com.
4.4.4 Wireless
Use these screens to manage your wireless Access Points.
4.4.5 Interface
Most of the features that use interfaces support Ethernet and VLAN interfaces.
Note: When you create an interface, no security is applied to it until you assign it to a
zone first.
4.4.6 Policy Routes
Use policy routes to override the NXC’s default routing behavior in order to send
packets through the appropriate interface. You can also use policy routes for
bandwidth management (out of the NXC), port triggering, and general NAT on the
source address. You have to set up the criteria, next-hops, and NAT settings first.
MENU ITEM(S)
Configuration > Licensing > Signature Update
PREREQUISITES
Registration (for anti-virus and IDP/application patrol), Internet
access to myZyXEL.com
MENU ITEM(S)
Configuration > Network > Wireless.
PREREQUISITES
Radio profiles, SSID profiles, and security profiles
MENU ITEM(S)
Configuration > Network > Interface.
PREREQUISITES
None
WHERE USED
Zones, device HA, policy routes, static routes, NAT, application patrol
MENU ITEM(S)
Configuration > Network > Routing > Policy Routes
PREREQUISITES
Criteria: users, user groups, interfaces (incoming), addresses (source,
destination), address groups (source, destination), schedules,
services, service groups
Next-hop: addresses (HOST gateway), interfaces
NAT: addresses (translated address), services and service groups
(port triggering)