Chapter 28 Services
NXC5200 User’s Guide
416
28.2.1 Add/Edit Service Rule
The Add/Edit Service Rule screen allows you to create a new service or edit an
existing one. To access this screen, go to the Service screen and click either the
Add icon or an Edit icon.
Figure 188
Configuration > Object > Service > Service > Add/Edit
The following table describes the labels in this screen.
Name
This field displays the name of each service.
Content
This field displays a description of each service.
Table 154
Configuration > Object > Service > Service (continued)
LABEL
DESCRIPTION
Table 155
Configuration > Object > Service > Service > Add/Edit
LABEL
DESCRIPTION
Name
Type the name used to refer to the service. You may use 1-31
alphanumeric characters, underscores(
_
), or dashes (-), but the first
character cannot be a number. This value is case-sensitive.
IP Protocol
Select the protocol the service uses. Choices are: TCP, UDP, ICMP, and
User Defined.
Starting Port
Ending Port
This field appears if the IP Protocol is TCP or UDP. Specify the port
number(s) used by this service. If you fill in one of these fields, the
service uses that port. If you fill in both fields, the service uses the range
of ports.
ICMP Type
This field appears if the IP Protocol is ICMP Type.
Select the ICMP message used by this service. This field displays the
message text, not the message number.
IP Protocol
Number
This field appears if the IP Protocol is User Defined.
Enter the number of the next-level protocol (IP protocol). Allowed values
are 0 - 255.
OK
Click OK to
save your changes back to the NXC.
Cancel
Click Cancel to exit this screen without saving your changes.